The short version of heptapeptide fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-01-27 and is reviewed periodically as new material appears.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Reversed-phase HPLC retention time versus reference standard | Retention depends on column, gradient, and ion-pairing agent |
| Mass confirmation | Electrospray or MALDI mass spectrometry | Doubly protonated ion near m/z 377 is consistent with about 752 Da |
| Typical purity specification | 95 percent or higher by chromatographic peak area | Lower values suggest truncated or modified peptide species |
| Storage of lyophilized powder | -20 °C, desiccated, protected from light | Powder tolerates long storage better than solution |
| Storage of solution | 2-8 °C for short periods | Freeze-thaw cycling promotes aggregation and surface adsorption |
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Quantification in biological matrices relies on liquid chromatography coupled to tandem mass spectrometry with stable-isotope internal standards. Low plasma concentrations and adsorption to container surfaces both complicate measurement. Solid-phase extraction is often needed to reduce matrix interference before injection. Reported limits of quantification differ widely between laboratories, which makes direct comparison of pharmacokinetic results difficult and limits meta-analysis.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Characterization of Selank in laboratory settings relies on standard peptide analytical techniques. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities and degradation products, while mass spectrometry confirms molecular identity through accurate mass measurement. Amino acid analysis and peptide sequencing verify the primary structure when reference material is unavailable. Because Selank is a short chain, fragmentation-based analysis produces a diagnostic ion pattern that supports confident identification.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Quality assessment of Selank samples typically combines purity determination with identity confirmation and counter-ion analysis. Purity is usually reported as a percentage by chromatographic area, with values above 95 percent often quoted for research-grade material. Water content and residual solvents are checked in lyophilized batches because they affect both stability and accurate mass determination. A reported purity figure does not by itself establish that a sample is the intended sequence, so orthogonal methods are needed to rule out sequence isomers or truncation products.
Limited maceration, early pressing, and early racking to limit contact time of the LAB with potential nutrient sources Maintain sulfur dioxide levels to at least 25 ppm of "free" (unbound) SO2, depending on the pH of the wine, this may mean an addition of 50–100 mg/L of SO2 Maintain pH levels below 3.3 Keep the wine cool at temperatures between 10 and 14 °C (50. 0 to 57.2 °F) Filter the wine at bottling with at least a 0.45-micron membrane filter to prevent any bacteria from making it into the bottle In addition, winemakers can use chemical and biological inhibitors such as lysozyme, nisin, dimethyl dicarbonate (Velcorin), and fumaric acid, though some (like Verlcorin) are restricted in winemaking countries outside the United States. Fining agents, such as bentonite, and putting the wine through cold stabilization will also remove potential nutrients for LAB, thus inhibiting malolactic fermentation. Some experimentation with the use of bacteriophages (viruses that infect bacteria) has been conducted to limit malolactic fermentations, but disappointing results in the cheesemaking industry have led to skepticism about the practical use of bacteriophages in winemaking.
Compound C00236 at KEGG Pathway Database. Enzyme 2.7.2.3 at KEGG Pathway Database. Compound C00197 at KEGG Pathway Database. Enzyme 5.4.2.1 at KEGG Pathway Database. Compound C00631 at KEGG Pathway Database. Click on genes, proteins and metabolites below to link to respective articles.
On Valve's official website circa 2010, his function was described as follows: "Kelly is Valve's senior audio producer, responsible for creating sound effects & music." Around March 2011, Kelly Bailey left Valve with colleague Mike Dussault to work on their project Sunspark Labs LLC, launched in December 2010, developing iOS applications, their first being "Morfo", released in June 2011. The news caused some concern and displeasure from the Steam community due to the lack of any public farewell or notification regarding Bailey's departure. However, at a press conference in February 2014, Mike Morasky (the current composer at Valve), stated that Kelly Bailey was working with Valve again. On 24 September 2015, a collection of new music composed by Bailey was released as a custom music kit in Counter-Strike: Global Offensive titled Hazardous Environments. The music kit's description states that it was "inspired by the darker side of the Half-Life universe". On 18 March 2016, Forbes wrote that Bailey is no longer with Valve but that he has created his own video game company, IndiMo Labs, and that he had been spending sixteen hours a day for the previous seven months as the sole developer behind Vanishing Realms: Rite of Steel, a virtual reality video game with RPG elements for the HTC Vive. The game released as an early access title on Steam on 5 April 2016, the same day the HTC Vive was launched.
Sources: en.wikipedia.org
Competition with analogs For releasing the His-tagged protein from the carrier, a compound is used that has a structure similar to the His-tag and which also forms a coordination complex with the immobilized metal ions. Such a compound added to the His-tagged protein on the carrier competes with the protein for the immobilized metal ions. The compound added at high concentration replaces virtually all carrier-bound protein which is thus eluted from the carrier. Imidazole is the side chain of histidine and is typically used at a concentration of 100 - 500 mM for elution. Histidine can also be used.
=== 50 and older === For older people (over 50 years old) and people with known or suspected ischemic heart disease, levothyroxine therapy should not be initiated at the full replacement dose. Since thyroid hormone increases the heart's oxygen demand by increasing heart rate and contractility, starting at higher doses may cause an acute coronary syndrome or an abnormal heart rhythm.
Anima and animus—(archetype) the contrasexual aspect of a person's psyche. In a woman's psyche, her inner personal masculine is conceived as a complex and an archetypal image; in a man's psyche, his inner personal feminine is conceived both as a complex and an archetypal image. Archetype—a concept "borrowed" from anthropology to denote supposedly universal and recurring mental images or themes. Jung's descriptions of archetypes varied over time. Archetypal images—universal symbols that mediate opposites in the psyche, often found in religious art, mythology, and fairy tales across cultures. Collective unconscious—aspects of unconsciousness experienced by all people in different cultures. Complex—the repressed organisation of images and experiences that governs perception and behaviour. Extraversion and introversion—personality traits of degrees of openness or reserve contributing to psychological type. Individuation—the process of fulfilment of each individual "which negates neither the conscious or [sic] unconscious position but does justice to them both". Interpersonal relationship—the way people relate to others reflects how they relate to themselves. This may also be extended to relations with the natural environment. Numinous—a healing, transformative or destructive spiritual power. Also, an invisible power inherent in an object. Jung develops the concept from the work of Rudolf Otto, who based it on the Latin numen. Persona—element of the personality that arises "for reasons of adaptation or personal convenience"—the "masks" one puts on in various situations.
Sources: en.wikipedia.org
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.
Lyophilized powder is normally stored desiccated at -20 °C, protected from light and moisture. Powder kept under these conditions is generally stable for long periods. Solutions are less stable and are usually prepared immediately before use.
A purity value from one chromatographic method does not capture every possible impurity. Related peptides with similar retention behavior, counterions, and residual solvents may not appear in the same analysis. Independent testing with an orthogonal method provides stronger assurance of identity and content.
Selank is a seven-amino-acid peptide built from the tuftsin sequence plus a Pro-Gly-Pro tail. It is produced by chemical synthesis rather than extracted from a natural source. The free peptide is usually supplied as a lyophilised powder or in an aqueous formulation.