Semax raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2025-12-27 and is reviewed periodically as new material appears.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Quality assessment of Selank samples typically combines purity determination with identity confirmation and counter-ion analysis. Purity is usually reported as a percentage by chromatographic area, with values above 95 percent often quoted for research-grade material. Water content and residual solvents are checked in lyophilized batches because they affect both stability and accurate mass determination. A reported purity figure does not by itself establish that a sample is the intended sequence, so orthogonal methods are needed to rule out sequence isomers or truncation products.
Characterization of Selank in laboratory settings relies on standard peptide analytical techniques. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities and degradation products, while mass spectrometry confirms molecular identity through accurate mass measurement. Amino acid analysis and peptide sequencing verify the primary structure when reference material is unavailable. Because Selank is a short chain, fragmentation-based analysis produces a diagnostic ion pattern that supports confident identification.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Reversed-phase HPLC retention time versus reference standard | Retention depends on column, gradient, and ion-pairing agent |
| Mass confirmation | Electrospray or MALDI mass spectrometry | Doubly protonated ion near m/z 377 is consistent with about 752 Da |
| Typical purity specification | 95 percent or higher by chromatographic peak area | Lower values suggest truncated or modified peptide species |
| Storage of lyophilized powder | -20 °C, desiccated, protected from light | Powder tolerates long storage better than solution |
| Storage of solution | 2-8 °C for short periods | Freeze-thaw cycling promotes aggregation and surface adsorption |
Selank is a hydrophilic peptide and dissolves readily in water and in aqueous buffers. The lyophilised powder is typically a white to off-white solid. Because short peptides are prone to hydrolysis and oxidation, handling benefits from limiting exposure to heat, moisture and strong light. Working solutions are commonly prepared in sterile water or saline, and repeated freeze-thaw cycles are avoided to reduce aggregation and loss of activity. These practices reflect general laboratory convention rather than published stability specifications.
Dry powder is normally held at -20 degrees Celsius or lower, in a sealed container with desiccant and protection from light. Reconstituted solutions are usually kept at 2 to 8 degrees Celsius for short periods and frozen for longer ones. Proline residues at several positions are generally associated with some resistance to peptidase attack, but chemical stability still declines at neutral to alkaline pH and at elevated temperature. Exact shelf-life figures are product-specific and are not standardised across suppliers.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, frequently abbreviated as TKPRPGP. It was designed as a structural analogue of tuftsin, a naturally occurring tetrapeptide released by enzymatic cleavage of the immunoglobulin heavy chain. The two additional proline residues at the C-terminal end extend the parent chain and change how the molecule behaves in solution. The free peptide has a calculated molecular mass of approximately 751.9 g/mol and is generally supplied as a lyophilised white to off-white powder.
Development work on the compound began in the 1980s and 1990s at the Institute of Molecular Genetics in Moscow, within the same research programme that produced the peptide Semax. Early investigators sought a tuftsin derivative with improved resistance to enzymatic breakdown and with activity in the central nervous system after peripheral administration. Most of the primary literature from this period was published in Russian, a factor that still shapes how easily the findings can be checked by outside groups.
Naming for this compound is not fully standardised in English sources. The spelling Selanc appears in some transliterations, and catalogue entries may instead list the peptide sequence itself as the identifier. Reference material sometimes groups it with other short synthetic peptides studied for behavioural effects, which can create confusion when citations are compared. Distinguishing the exact sequence from related tuftsin analogues is therefore a practical first step when reviewing any dataset or specification sheet.
Selank is a synthetic heptapeptide developed in Russia as a structural analogue of tuftsin, a naturally occurring immunomodulatory tetrapeptide. Its sequence, Thr-Lys-Pro-Arg-Pro-Gly-Pro, keeps the tuftsin core at the N-terminus and appends a Pro-Gly-Pro tail. Researchers at the Institute of Molecular Genetics in Moscow synthesized the compound during the 1990s while searching for peptides with combined anxiolytic and immunomodulatory activity. The added tail was intended to resist enzymatic cleavage and prolong the molecule's presence in circulation.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Environmental vegetarianism is based on the concern that the production of meat and animal products for mass consumption, especially through factory farming, is environmentally unsustainable. According to a 2006 United Nations initiative, the livestock industry is one of the largest contributors to environmental degradation worldwide, and modern practices of raising animals for food contribute on a "massive scale" to air and water pollution, land degradation, climate change, and loss of biodiversity. The initiative concluded that "the livestock sector emerges as one of the top two or three most significant contributors to the most serious environmental problems, at every scale from local to global." In addition, animal agriculture is a large source of greenhouse gases. According to a 2006 report it is responsible for 18% of the world's greenhouse gas emissions as estimated in 100-year CO2 equivalents. Livestock sources (including enteric fermentation and manure) account for about 3.1 percent of US anthropogenic GHG emissions expressed as carbon dioxide equivalents. This EPA estimate is based on methodologies agreed to by the Conference of Parties of the UNFCCC, with 100-year global warming potentials from the IPCC Second Assessment Report used in estimating GHG emissions as carbon dioxide equivalents. Meat produced in a laboratory (called in vitro meat) may be more environmentally sustainable than regularly produced meat. Reactions of vegetarians vary.
=== Metformin === Reduced serum levels of vitamin B12 occur in up to 30% of people taking long-term anti-diabetic metformin. Deficiency does not develop if dietary intake of vitamin B12 is adequate or prophylactic B12 supplementation is given. If the deficiency is detected, metformin can be continued while the deficiency is corrected with B12 supplements.
== Applications == Metamaterials are under consideration for many applications. Metamaterial antennas are commercially available. In 2007, one researcher stated that for metamaterial applications to be realized, energy loss must be reduced, materials must be extended into three-dimensional isotropic materials and production techniques must be industrialized. All-dielectric subwavelength metasurface focusing lens operating in the near infrared has been demonstrated by the Shalaev group in collaboration with the Raytheon team. This lens is currently used in Raytheon defense system products.
=== Betaines and similar compounds === The compound trimethylglycine, named as "betaine", contain the same structural motif, a quaternary nitrogen atom with a carboxylate group attached to it via a –CH2– link. All compounds whose structure includes this motif are known as betaines. Betaines do not isomerize because the chemical groups attached to the nitrogen atom are not labile. These compounds may be classed as permanent zwitterions, as isomerisation to a molecule with no electrical charges does not occur, or is very slow. Other examples of permanent zwitterions include phosphatidylcholines, which also contain a quaternary nitrogen atom, but with a negatively-charged phosphate group in place of a carboxylate group; sulfobetaines, which contain a quaternary nitrogen atom and a negatively charged sulfonate group; and pulmonary surfactants such as dipalmitoylphosphatidylcholine. Lauramidopropyl betaine is the major component of cocamidopropyl betaine.
Sources: en.wikipedia.org
== Cultivation == Successful cultivation requires warm to hot summers with high sunshine levels; even partial shade will reduce the yield substantially. It also prefers rich, well-drained soil. The seed is harvested by cutting the flower heads off the stalks when the seed is beginning to ripen. The seed heads are placed upside down in a paper bag and left in a warm, dry place for a week. The seeds then separate from the stems easily for storage in an airtight container. These plants, like their fennel and parsley relatives, often are eaten by black swallowtail caterpillars in areas where that species occurs. For this reason, they may be included in some butterfly gardens.
International Chemical Safety Card 0275 (gas) International Chemical Safety Card 0695 (solution) NIOSH Pocket Guide to Chemical Hazards. "#0293". National Institute for Occupational Safety and Health (NIOSH). Entry for "Formaldehyde" on the Australian National Pollutant Inventory Formaldehyde from ChemSub Online Prevention guide—Formaldehyde in the Workplace (PDF) from the IRSST Formaldehyde from the National Institute for Occupational Safety and Health IPCS Health and Safety Guide 57: Formaldehyde IPCS Environmental Health Criteria 89: Formaldehyde SIDS Initial Assessment Report for Formaldehyde from the Organisation for Economic Co-operation and Development (OECD) Formaldehyde in the Pesticide Properties DataBase (PPDB)
At Australia's federation in 1901, the Constitution section 51(xxxv) empowered the making of "laws for the peace, order, and good government of the Commonwealth with respect to... conciliation and arbitration for the prevention and settlement of industrial disputes extending beyond the limits of any one state". This was used to pass the Commonwealth Conciliation and Arbitration Act 1904 where a "dispute" would trigger federal jurisdiction between trade unions and employers, and this was meant to make strikes illegal or unnecessary, although in fact strikes remained "not uncommon". The Commonwealth Court of Conciliation and Arbitration (CCCA) could hear disputes, and make "awards" for fair wages and conditions across an industry if there was no agreement reached, or regulate any "industrial matters". With favourable governments in power, some courts were progressive, and in the landmark Harvester case the CCCA determined that the employer, Hugh Victor McKay that made harvesting machinery, was required to pay "fair and reasonable wages", or pay an excise tax on exports, under the Excise Tariff Act 1906. What was "fair and reasonable", said Higgins J depended on "the normal needs of an average employee, regarded as a human being in a civilised community", and this was to be found by imagining a hypothetical collective agreement, not individual bargaining with the "usual, but unequal, contest, the "higgling of the market" for labour, with the pressure for bread on one side and the pressure for profits on the other".
Sources: en.wikipedia.org
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.
Lyophilized powder is normally stored desiccated at -20 °C, protected from light and moisture. Powder kept under these conditions is generally stable for long periods. Solutions are less stable and are usually prepared immediately before use.
A purity value from one chromatographic method does not capture every possible impurity. Related peptides with similar retention behavior, counterions, and residual solvents may not appear in the same analysis. Independent testing with an orthogonal method provides stronger assurance of identity and content.
The most common approach combines reverse-phase liquid chromatography with mass spectrometry. Chromatography separates the components while mass spectrometry confirms the molecular mass. Peptide sequencing or tandem mass analysis can further verify the amino acid order.